OpenMANET Raspberry Pi 4 Test Stand
From the Signals & Static build log: https://signalsandstatic.com

Holds one OpenMANET bench node: a Raspberry Pi 4 with the Seeed WM1302 HAT,
an upright SMA 915 MHz antenna, and a zip-tied GPS antenna.

FILES
  pi_test_stand.stl      printable part (mm)
  test_stand.FCStd       FreeCAD model (stand plus see-through reference parts)
  pi_test_stand.FCMacro  FreeCAD macro that rebuilds the stand from its parameters

PRINTING
  Prints flat, no supports. About 57 cm3 of filament. Any material is fine.
  Shelf gussets are 45 degrees; the shelf underside bridges about 18 mm.
  Print one per node.

HARDWARE
  4x M2.5 x 12 mm screws. They replace the short screws under the Pi, go up
     through the recessed holes in the bottom, and thread into the HAT's standoffs.
  Zip ties up to about 4.8 mm wide for the GPS antenna (two crossed tunnels)
     and the u.FL pigtail (two slots in the tower wall).

FIT
  SMA bulkhead hole is 6.6 mm (1/4-36 thread). It fit on the first print.
  If yours is tight or loose, change SMA_D in the macro and run it again.
  All of the Pi's ports overhang the base, so every plug stays reachable.
